36-16
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 36 Configuring Inverse Muliplexing over ATM
How to Configure ATM Class of Service
Example: Configuring an N-to-1 VCC Cell Mode
The following is a sample configuration of N-to-1 VCC cell mode:
!
interface ATM0/IMA0
no ip address
atm mcpt-timers 500 600 700
no atm enable-ilmi-trap
100/100 l2transport
cell-packing 10 mcpt-timer 2
encapsulation aal0
xconnect 25.25.25.25 125 encapsulation mpls
!
The following is a sample configuration for AAL5 SDU mode:
!
interface ATM0/IMA0
no ip address
no atm enable-ilmi-trap
100/100 l2transport
encapsulation aal5
xconnect 25.25.25.25 125 encapsulation mpls
!
Example: Configuring an N-to-1 VPC Cell Mode
The following is a sample configuration of N-to-1 Permanent Virtual Circuit (VPC) cell mode.
!
interface ATM0/IMA0
no ip address
atm pvp 12 l2transport
xconnect 30.30.30.30 30 encapsulation mpls
!
Example: Configuring CBR
The following is a sample configuration of constant bit rate.
!
interface atm0/ima0
1/200 l2transport
cbr 16000
!
Example: Configuring UBR
The following is a sample configuration of constant bit rate.
!
interface atm0/ima0
1/200 l2transport
ubr 16000
!