Filter
Top Products
10-58
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 10 Configuring Ethernet OAM
Understanding Ethernet Loopback
• SPAN and Traffic generator cannot be used simultaneously since both uses the mirror mechanism.
• For Traffic generation over cross connect port-channel will not be supported for both internal and
external modes.
• Ethernet loopback and Traffic generator cannot be used simultaneously.
• After reload, the Traffic generator over cross connect should be rescheduled (stop and start).
• After cross connect flaps, the Traffic generator over cross connect should be rescheduled (stop and
start).
Configuring IP SLA for Traffic Generation
Complete these steps to configure IP SLA for traffic generation.
SUMMARY STEPS
1. configure terminal
2. ip sla sla_id
3. service-performance type ethernet dest-mac-addr destination mac-address interface type
number service instance number
4. aggregation | default | description | duration | exit | frequency | measurement-type direction |
no | profile | signature
5. default | exit | loss | no | throughput
6. exit
7. default | exit | inner-cos | inner-vlan | no | outer-cos | outer-vlan | packet-size | src-mac-addr
8. exit
9. direction {external | internal}
10. default | exit | no | rate-step
11. exit
DETAILED STEPS
Command or Action Purpose
Step 1
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 2
ip sla
sla_id
Example:
Router(config)# ip sla 100
Specify the SLA ID to start the IP SLA session.