Filter
Top Products
10-59
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 10 Configuring Ethernet OAM
Understanding Ethernet Loopback
Step 3
service-performance type ethernet dest-mac-addr
destination mac-address
interface
type number
service instance
number
Example:
Router(config-ip-sla)# service-performance type
ethernet dest-mac-addr 0001.0001.0001 interface
gigabitEthernet0/10 service instance 10
Specifies the service performance type as ethernet and the
destination MAC address in H.H.H format.
Specifies an interface type and number which traffic
generator uses to send the packets. Also, specifies the
service instance number that is required to create a service
instance on an interface. The range is 1 to 4096.
Step 4
aggregation | default | description | duration
| exit | frequency | measurement-type direction
| no | profile | signature
Example:
Router(config-ip-sla-service-performance)# prof
ile traffic direction external
Specify the type of service performance. The following are
the options:
• aggregation—Represents the statistics aggregation.
• default—Set a command to its defaults.
• description—Description of the operation.
• duration—Sets the service performance duration
configuration.
• frequency—Represents the scheduled frequency. The
options available are iteration and time. The range is 20
to 65535 seconds.
• measurement-type direction—Specifies the statistics
to measure traffic. The options available are external or
internal; the default option is Internal. If you use this
option, go to Step 5.
• profile—Specifies the service performance profile. If
you use the packet or traffic option, go to Step 7 or Step
9 respectively.
• signature—Specifies the payload contents.
Step 5
default | exit | loss | no | throughput
Example:
Router(config-ip-sla-service-performance-measur
ement)# throughput
Specifies the measurement type based on which the service
performance is calculated. The following are the options:
• default—Set a command to its defaults
• loss—Specifies the measurement such as frame loss.
• throughput—Specifies the measurement such as
average rate of successful frame delivery.
Step 6
exit
Exits the measurement mode.
Command or Action Purpose