Filter
Top Products
2-8
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 2 Licensing
Port or Interface Behavior
Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
Example: When 10gigUpgrade License is Installed
The following example shows how to install the 10gigUpgrade license:
Router# license install flash:10G-ac.lic
Installing licenses from "flash:10G-ac.lic"
Installing...Feature:10gigUpgrade...Successful:Supported
1/1 licenses were successfully installed
0/1 licenses were existing licenses
0/1 licenses were failed to install
Following is a sample output from the show license command:
Router# show license
Index 1 Feature: AdvancedMetroIPAccess
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
Index 2 Feature: IPBase
Index 3 Feature: Gige4portflexi
Index 4 Feature: 10gigUpgrade
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
Flexi License
When a flexi license is not present, ports 4 to 7 are enabled. Ports 0 to 3, and ports 8 to 11 are disabled.
This is the expected behavior. Interfaces that are disabled are in the administrative down state.
FLS-A901-4 flexi license is a combination of copper and SFP ports. This license is not tied to any port
types. If you purchase a single FL-A901-4 license and install it, four ports are enabled and if you have
two licenses, all the eight ports are enabled. You can purchase and install two flexi licenses in a router.
Note Flexi license is supported only on the Cisco ASR 901 10G router.
Example: When Flexi License is not Installed
The following error message appears when the flexi license is not installed and you use the
show ip interface command on the interface: