25-14
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter25 Configuring MLPPP
Configuring MLPPP Backhaul
• ppp multilink fragment maximum
• ppp multilink slippage
• ppp timeout multilink lost-fragment
Note If you have a bundle that requires the use of these options, contact Cisco support for assistance.
Configuring Additional MLPPP Settings
You can perform a variety of other configurations on an MLPPP bundle, including the following:
• Modifying the maximum fragment size
• Modifying fragmentation settings
• Enabling or disabling fragmentation
• Enabling or disabling interleaving
• Configuring multiclass MLPPP
Note For more information about configuring MLPPP, see theDial Configuration Guide, Cisco IOS Release
15.0S.
Configuring MPLS over the MLPPP on a Serial Interface
Complete the following steps to configure MPLS over the MLPPP link on a serial interface:
SUMMARY STEPS
1. enable
2. configure terminal
3. interface serial slot/port:time-slot
4. no ip address
5. encapsulation encapsulation-type
6. ppp multilink
7. ppp multilink group group-number
8. exit