Filter
Top Products
11-7
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 11 ITU-T Y.1731 Performance Monitoring
How to Configure ITU-T Y.1731 Performance Monitoring
Step 4
ethernet y1731 delay DMM domain
domain-name
{evc
evc-id
| vlan
vlan-id
} {mpid
target-mp-id
|
mac-address
target-address
} cos
cos
{source {mpid
source-mp-id
| mac-address
source-address
}}
Example:
Router(config-ip-sla)# ethernet y1731 delay DMM
domain xxx evc yyy mpid 101 cos 4 source mpid 100
Configures two-way delay measurement and enters
IP SLA Y.1731 delay configuration mode.
• DMM—Specifies that the frames sent are Delay
Measurement Message (DMM) synthetic frames.
• domain domain-name—Specifies the name of
the Ethernet maintenance Operations,
Administration & Maintenance (OAM) domain.
• evc evc-id—Specifies the EVC identification
name.
• vlan vlan-id—Specifies the VLAN identification
number. The range is from 1 to 4096.
• mpid target-mp-id—Specifies the maintenance
endpoint identification numbers of the MEP at
the destination. The range is from 1 to 8191.
• mac-address target-address—Specifies the
MAC address of the MEP at the destination.
• cos cos—Specifies, for this MEP, the class of
service (CoS) that will be sent in the Ethernet
message. The range is from 0 to 7.
• source—Specifies the source MP ID or MAC
address.
• mpid source-mp-id—Specifies the maintenance
endpoint identification numbers of the MEP
being configured. The range is from 1 to 8191.
• mac-address source-address—Specifies the
MAC address of the MEP being configured.
Step 5
aggregate interval
seconds
Example:
Router(config-sla-y1731-delay)# aggregate interval
900
(Optional) Configures the length of time during
which the performance measurements are conducted
and the results stored.
• seconds—Specifies the length of time in seconds.
The range is from 1 to 65535. The default is 900.
Command Purpose