Filter
Top Products
26-2
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 26 Onboard Failure Logging
Configuring OBFL
Configuring OBFL
Use the following commands to configure and verify OBFL:
Verifying OBFL Configuration
Example 1
Router# show logging onboard status
Devices registered with infra
Slot no.: 0 Subslot no.: 0, Device obfl0:
Application name clilog :
Path : obfl0:
CLI enable status : enabled
Platform enable status: enabled
Application name temperature :
Path : obfl0:
CLI enable status : enabled
Platform enable status: enabled
Example 2
Router # show logging onboard temperature ?
continuous Onboard logging continuous information
detail Onboard logging detailed information
end ending time and date
raw Onboard logging raw information
start starting time and date
status Onboard logging status information
summary Onboard logging summary information
Router# show logging onboard temperature continuous
--------------------------------------------------------------------------------
TEMPERATURE CONTINUOUS INFORMATION
--------------------------------------------------------------------------------
Sensor | ID |
--------------------------------------------------------------------------------
System 1
--------------------------------------------
Command Purpose
Router(conf)# hw-module
{all|slot|module}
{slotnumber/subslotnumber|modulenumber}
logging onboard
Example:
Router(conf)# hw-module
module 0
logging
onboard
Enables OBFL on the specified hardware module.
The no form of the command disables OBFL.
Router> show logging onboard
{slot|module}
{slotnumber/subslotnumber|modulenumber}
[status]
Shows the status of OBFL logging.
OBFL is enabled by default in Cisco ASR 901.
Router(conf)# clear logging onboard
Clears OBFL logging.