Filter
Top Products
39-35
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 39 Remote Loop-Free Alternate - Fast Reroute
Configuration Examples for Remote LFA-FRR
transit packet totals: receive 64465447, send 64465519
transit byte totals: receive 15987430856, send 15987448712
transit packet drops: receive 0, seq error 0, send 0
Verifying Remote LFA-FRR Configuration on SAToP
To verify the remote LFA-FRR configuration on SAToP, use the show commands described in the
following example.
Router# show mpls l2 vc 111 detail
Local interface: CE0/0 up, line protocol up, SATOP Basic 1 up
Destination address: 2.2.2.2, VC ID: 111, VC status: up
Output interface: Vlan300, imposed label stack {29 32}
Preferred path: not configured
Default path: active
Next hop: point2point
Create time: 17:54:25, last status change time: 17:54:25
Last label FSM state change time: 17:54:25
Signaling protocol: LDP, peer 2.2.2.2:0 up
Targeted Hello: 170.0.0.201(LDP Id) -> 2.2.2.2, LDP is UP
Graceful restart: not configured and not enabled
Non stop routing: not configured and not enabled
Status TLV support (local/remote) : enabled/supported
LDP route watch : enabled
Label/status state machine : established, LruRru
Last local dataplane status rcvd: No fault
Last BFD dataplane status rcvd: Not sent
Last BFD peer monitor status rcvd: No fault
Last local AC circuit status rcvd: No fault
Last local AC circuit status sent: No fault
Last local PW i/f circ status rcvd: No fault
Last local LDP TLV status sent: No fault
Last remote LDP TLV status rcvd: No fault
Last remote LDP ADJ status rcvd: No fault
MPLS VC labels: local 20, remote 32
Group ID: local 0, remote 0
MTU: local 0, remote 0
Remote interface description:
Sequencing: receive disabled, send disabled
Control Word: On (configured: autosense)
Configuration Examples for Remote LFA-FRR
This section provides sample configuration examples for Remote LFA-FRR feature on the
Cisco ASR 901 router.
• Example: Configuring Remote LFA-FRR for IS-IS, page 39-36
• Example: Configuring Remote LFA-FRR for OSPF, page 39-36
• Example: Configuring Remote LFA-FRR Globally, page 39-36
• Example: Configuring Remote LFA-FRR on a GigabitEthernet Interface, page 39-37
• Example: Configuring Remote LFA-FRR on an SVI Interface, page 39-37
• Example: Configuring EoMPLS Pseudowire Redundancy over FRR, page 39-37