28-6
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 28 Configuring Link Layer Discovery Protocol
Where to Go Next
This is an example to enable an LLDP TLV on a supported interface:
Router> enable
Router# configure terminal
Router(config)# interface ethernet 0/1
Router(config-if)# lldp tlv-select system-description
Router(config-if)# end
Where to Go Next
For additional information on configuring LLDP, see the documentation listed in the “Related
Documents” section on page 28-7.