Filter
Top Products
42-11
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 42 IPv6 Multicast
Configuring IPv6 Multicast
Configuring PIM SSM Options
To configure PIM Source-Specific Multicast options, complete the following steps.
SUMMARY STEPS
1. enable
2. configure terminal
3. ipv6 pim
4. interface type number
5. ipv6 pim hello-interval interval-in-seconds
6. ipv6 pim join-prune-interval interval-in-seconds
DETAILED STEPS
Command Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
ipv6 pim
Example:
Router(config)# ipv6 pim
Configures PIM, if it is disabled. PIM runs on every interface after
configuring IPv6 multicast routing.
Step 4
interface
type number
Example:
Router(config)# interface
gigabitethernet 0/1
Specifies an interface type and number, and enters interface
configuration mode.
Step 5
ipv6 pim hello-interval
interval-in-seconds
Example:
Router(config-if)# ipv6 pim
hello-interval 45
Configures periodic hello interval for this interface. Default is 30
seconds. Periodic hellos are sent out at intervals randomized by a
small amount instead of on exact periodic interval.
Step 6
ipv6 pim join-prune-interval
interval-in-seconds
Example:
Router(config-if)# ipv6 pim
join-prune-interval 75
Configures periodic Join-Prune announcement interval for this
interface. Default is 60 seconds.