21-13
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 21 Configuring Pseudowire
Configuring Pseudowire
Step 14
xconnect
peer-router-id vcid
{pseudowire-class
name
}
Example:
Router(config-if-cem)# xconnect
30.30.30.2 305 pw-class udpClass
Binds an attachment circuit to the CEM interface to create a pseudowire.
This example creates a pseudowire by binding the CEM circuit 5 to the
remote peer 30.30.30.2.
Note When creating IP routes for a pseudowire configuration, we
recommend that you build a route from the cross-connect address
(LDP router-ID or loopback address) to the next hop IP address,
such as ip route 30.30.30.2 255.255.255.255 1.2.3.4.
Step 15
udp port local
<local-udp-port>
remote <
remote-udp-port>
Example:
Router(config-if-cem-xconn)# udp
port local 49150 remote 55000
Specifies a local and remote UDP port for the connection. Valid port
values for SAToP pseudowires using UDP are from 49152–57343.
Step 16
exit
Example:
Router(config-if-cem-xconn)# exit
Exits the CEM interface.
Step 17
exit
Example:
Router(config-if)# exit
Exits the configuration mode.
Command Purpose