Filter
Top Products
2-9
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 2 Licensing
Port or Interface Behavior
Router# show ip interface brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0 unassigned YES unset administratively down down
GigabitEthernet0/1 unassigned YES unset administratively down down
GigabitEthernet0/2 unassigned YES unset administratively down down
GigabitEthernet0/3 unassigned YES unset administratively down down
GigabitEthernet0/4 unassigned YES unset down down
GigabitEthernet0/5 unassigned YES unset down down
GigabitEthernet0/6 unassigned YES unset down down
GigabitEthernet0/7 unassigned YES unset down down
GigabitEthernet0/8 unassigned YES unset administratively down down
GigabitEthernet0/9 unassigned YES unset administratively down down
GigabitEthernet0/10 unassigned YES unset administratively down down
GigabitEthernet0/11 unassigned YES unset administratively down down
FastEthernet0/0 unassigned YES NVRAM administratively down down
Vlan1 unassigned YES unset down down
Example: When Flexi License is Installed
Following is a sample output from the show license command:
Router# show license
Index 1 Feature: AdvancedMetroIPAccess
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
Index 2 Feature: IPBase
Index 3 Feature: Gige4portflexi
1588BC License
When the SL-A901-T 1588BC license is not installed, the PTP boundary clock cannot be configured.
For more information on configuring the PTP boundary clock, see PTP Boundary Clock.
Example: When 1588BC License is not Installed
The following error message appears on configuring the PTP boundary clock, when the 1588BC license
is not installed:
Note Though an error message appears on configuring the PTP boundary clock, the running-config file
accepts the PTP boundary clock configuration. This configuration can be saved. However, the PTP
boundary clock is not configured in the hardware, and is inactive.
Router(config)# ptp clock boundary domain 0
%ERROR: Boundary Clock needs a separate license. Please install license and reconfigure
PTP.
Router(config-ptp-clk)#
Example: When 1588BC License is Installed
The following example shows how to install the 1588BC license:
Router# license install flash:CAT1632U029_20121005013805577.lic