Filter
Top Products
38-6
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 38 Storm Control
Configuring Error Disable Recovery
Monitoring Error Disable Recovery
To display the information about the error-disable recovery timer, use the show command described in
the following example.
Router# show errdisable recovery
ErrDisable Reason Timer Status
----------------- --------------
udld Disabled
bpduguard Disabled
security-violatio Disabled
channel-misconfig Disabled
vmps Disabled
pagp-flap Disabled
dtp-flap Disabled
link-flap Disabled
lsgroup Enabled
l2ptguard Disabled
psecure-violation Disabled
gbic-invalid Disabled
dhcp-rate-limit Disabled
mac-limit Disabled
unicast-flood Disabled
storm-control Enabled
arp-inspection Disabled
loopback Disabled
link-monitor-fail Disabled
oam-remote-failur Disabled
oam-remote-failur Disabled
oam-remote-failur Disabled
dot1ad-incomp-ety Disabled
dot1ad-incomp-tun Disabled
mlacp-minlink Disabled
Timer interval: 30 seconds
Interfaces that will be enabled at the next timeout:
Interface Errdisable reason Time left(sec)
---------- --------------------- --------------
Gi0/3 storm-control 4
Step 4
errdisable recovery interval
seconds
Example:
Router(config)# errdisable recovery
interval 30
Configures the period to recover from a specified error-disable
cause.
• seconds—Specifies the time to recover from a specified
error-disable cause.
Step 5
end
Example:
Router(config)# end
Exits global configuration mode and enters the privileged EXEC
mode.
Command Purpose