Filter
Top Products
8-28
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 8 Configuring Ethernet Virtual Connections
Monitoring EVC
Monitoring EVC
Note Statistics are not available in the service instance command. To look at flow statistics, you need to
configure a class default policy on the service instance.
Table 8-2 Supported show Commands
Command Description
show ethernet service evc [id evc-id |
interface interface-id] [detail]
Displays information about all EVCs, or a specific EVC when you enter an EVC
ID, or all EVCs on an interface when you enter an interface ID. The detail
option provides additional information about the EVC.
show ethernet service instance [id
instance-id interface interface-id |
interface interface-id] {[detail] | [stats]}
Displays information about one or more service instance (EFPs). If you specify
an EFP ID and interface, only data pertaining to that particular EFP is displayed.
If you specify only an interface ID, data is displayed for all EFPs on the
interface.
show bridge-domain [n] Displays all the members of the specified bridge-domain, if a bridge-domain
with the specified number exists.
If you do not enter n, the command displays all the members of all
bridge-domains in the system.
show bridge-domain n split-horizon
[group {group_id | all}]
Displays all the members of bridge-domain n that belong to split horizon group
0, when you do not specify a group group_id with this command.
If you specify a numerical group_id, this command displays all the members of
the specified group id.
When you enter group all, the command displays all members of any split
horizon group.
show ethernet service instance detail This command displays detailed service instance information, including Layer
2 protocol information. This is an example of the output:
Router# show ethernet service instance detail
Service Instance ID: 1
Associated Interface: Ethernet0/0
Associated EVC:
L2protocol tunnel lacp
CE-Vlans:
State: Up
EFP Statistics:
Pkts In Bytes In Pkts Out Bytes Out
0 0 0 0
show mac address-table This command displays dynamically learned or statically configured MAC
security addresses.
show mac address-table bridge-domain
bridge-domain id
This command displays MAC address table information for the specified bridge
domain.
show mac address-table count
bridge-domain bridge-domain id
This command displays the number of addresses present for the specified bridge
domain.
show mac address-table learning
bridge-domain bridge-domain id
This command displays the learning status for the specified bridge domain.