Filter
Top Products
3-2
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 3 First-Time Configuration
Setup Mode
Using Setup Mode
The setup command facility appears in your PC terminal emulation program window. To create a basic
configuration for your router, perform the following:
• Complete the steps in the “Configuring Global Parameters” section on page 3-2
• Complete the steps in the “Completing the Configuration” section on page 3-4
Note If you made a mistake while using the setup command facility, exit the facility and run it again.
Press Ctrl-C, and type setup at the enable mode prompt (1900#).
Configuring Global Parameters
Complete the following steps to configure global parameters.
Step 1 Power on the router. Messages appear in the terminal emulation program window.
Caution Do not press any keys on the keyboard until the messages stop. Any keys that you press during this time
are interpreted as the first command entered after the messages stop, which might cause the router to
power off and start over. Wait a few minutes. The messages stop automatically.
The messages look similar to the following:
System Bootstrap, Version 15.1(2r)SNG, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2011 by cisco Systems, Inc.
Compiled Tue 25-Oct-11 12:09 by tinhuang
P2020 platform with 524288 Kbytes of main memory
program load complete, entry point: 0x2000000, size: 0x1d29954
Self decompressing the image :
##########################################################################################
##########################################################################################
##########################################################################################
##########################################################################################
##########################################################################################
##########################################################################################
################################### [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706