Filter
Top Products
2-7
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 2 Licensing
Port or Interface Behavior
Installing licenses from "flash:FHAK13101A1_20110811190230024_fls-a901-4t.lic"
Installing...Feature:Fls-a901-4t...Successful:Supported
1/1 licenses were successfully installed
0/1 licenses were existing licenses
0/1 licenses were failed to install
Router#*Oct 5 17:23:14.487: %LICENSE-6-INSTALL: Feature Fls-a901-4t 1.0 was installed in
this device. UDI=MWR-3941-TEST:FHAK13101A1; StoreIndex=2:Primary License Storage
Router(config)# interface gig 0/0
Router(config-if)# no shutdown
When the port based license is installed for copper or SFP ports, the corresponding ports are enabled.
Following is a sample output from the show ip interface command:
Router# show ip interface brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0 unassigned YES unset up up
GigabitEthernet0/1 unassigned YES unset administratively down down
GigabitEthernet0/2 unassigned YES unset administratively down down
…..
Note Combo ports are either copper or SFP ports depending on the configuration specified in the media-type
command.
10gigUpgrade License
When you do not have the 10gigUpgrade license, the 10 Gigabit Ethernet ports are enabled in 1 Gigabit
Ethernet mode. Install the 10gigUpgrade license to enable new 10 Gigabit Ethernet ports in 10Gigabit
Ethernet mode. To enable 1 Gigabit Ethernet mode, 1 Gigabit Ethernet SFPs have to be used on both the
ends. There is no speed command to control the speed and this depends on the type of the SFP. The 10
Gigabit Ethernet ports does not support 100M speed. You can connect 10 Gigabit Ethernet SFP+ to 10
Gigabit Ethernet ports only.
Example: When 10gigUpgrade License is not Installed
The following error message appears when the 10gigUpgrade license is not installed and you use the
show interface command:
Router# show interface Ten0/1
TenGigabitEthernet0/1 is down, line protocol is down (notconnect)
Hardware is TenGigabit Ethernet, address is 2c54.2dd6.c10e (bia 2c54.2dd6.c10e)
MTU 9216 bytes, BW 10000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Unknown, Unknown, media type is H10GB-CU3M
output flow-control is unsupported, input flow-control is unsupported
LICENSE not available or 1G SFP ( Interface in 1G mode )
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer