Cisco Systems A9014CFD Router User Manual


 
2-6
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 2 Licensing
Port or Interface Behavior
Port Based License, page 2-6
10gigUpgrade License, page 2-7
Flexi License, page 2-8
1588BC License, page 2-9
Port Based License
When a port based license is not present, ports 4 to 7 are enabled. Ports 0 to 3, and ports 8 to 11 are
disabled. This is the expected behavior. Interfaces that are disabled are in the administrative down state.
Example: When Port Based License is not Installed
The following error message appears when the port based license is not installed and you use the
no shutdown command on the interface:
Router# show ip interface brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0 unassigned YES unset administratively down down
GigabitEthernet0/1 unassigned YES unset administratively down down
GigabitEthernet0/2 unassigned YES unset administratively down down
GigabitEthernet0/3 unassigned YES unset administratively down down
GigabitEthernet0/4 unassigned YES unset down down
GigabitEthernet0/5 unassigned YES unset down down
GigabitEthernet0/6 unassigned YES unset down down
GigabitEthernet0/7 unassigned YES unset down down
GigabitEthernet0/8 unassigned YES unset administratively down down
GigabitEthernet0/9 unassigned YES unset administratively down down
GigabitEthernet0/10 unassigned YES unset administratively down down
GigabitEthernet0/11 unassigned YES unset administratively down down
FastEthernet0/0 unassigned YES NVRAM administratively down down
Vlan1 unassigned YES unset down down
Router#
Router(config-if)# interface gig 0/0
Router(config-if)# no shutdown
Router(config-if)#
*Oct 5 14:22:27.743: %LICENSE-1-REQUEST_FAILED: License request for feature fls-a901-4t
1.0 failed. UDI=MWR-3941:FHAK13101A1
Router# show interface gigabitEthernet 0/0
GigabitEthernet0/0 is administratively down, line protocol is down (disabled)
…….
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full Duplex, 1000Mbps, link type is force-up, media type is RJ45
output flow-control is unsupported, input flow-control is unsupported
LICENSE not available! Interface disabled
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Example: When Port Based License is Installed
The following example shows how to install the port based license:
Router# license install flash:FHAK13101A1_20110811190230024_fls-a901-4t.lic