Filter
Top Products
31-11
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 31 Microwave ACM Signaling and EEM Integration
Configuration Examples for Microwave ACM Signaling and EEM Integration
To display microwave bandwidth statistics of an interface, use the following show command.
Router# show ethernet event microwave statistic [interface]
Microwave Bandwidth Statistics for GigabitEthernet0/0/2
Total VSM Receive Count : 145
Total VSM Drop Count : 0
Number of transitions into Degraded state : 2
Configuration Examples for Microwave ACM Signaling and
EEM Integration
This section provides sample configuration examples for Microwave ACM Signaling and EEM
Integration feature on the Cisco ASR 901 router.
• Example: Configuring CFM, page 31-11
• Example: Configuring EEP Applet, page 31-11
• Example: Configuring Event Handler, page 31-15
Example: Configuring CFM
The following is a sample configuration of CFM.
!
ethernet cfm domain outer level 3
service microwave1 evc V60 vlan 60 direction down
continuity-check
!
ethernet evc V60
!
interface GigabitEthernet0/11
!
service instance 60 ethernet V60
encapsulation dot1q 60
rewrite ingress tag pop 1 symmetric
bridge-domain 60
!
Example: Configuring EEP Applet
The following is a sample EEM script to configure metric on a microwave link and adjust a QoS policy
according to the ethernet event parameters sent through OAM.
Note You should have one SVI/BD per physical link. Also, one EEM script is required per physical link. In
all, there should be two EEM scripts and two SVI/BDs:
! ACM script
no event manager applet ACM62
event manager applet ACM62