Filter
Top Products
10-44
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 10 Configuring Ethernet OAM
Step 6
ethernet oam link-monitor frame-period
{threshold {high {high-frames | none} | low
{low-frames}} | window frames}
(Optional) Configure high and low thresholds for the
error-frame period that triggers an error-frame-period link
event.
• Enter the threshold high high-frames command to set
a high threshold in number of frames. The range is 1 to
65535. You must enter a high threshold.
• Enter the threshold high none command to disable the
high threshold.
• Enter the threshold low low-frames command to set a
low threshold in number of frames. The range is 0 to
65535. The default is 1.
• Enter the window frames command to set the a polling
window size in number of frames. The range is 1 to
65535; each value is a multiple of 10000 frames. The
default is 1000.
Step 7
ethernet oam link-monitor frame-seconds
{threshold {high {high-seconds | none} | low
{low-seconds}} | window milliseconds}
(Optional) Configure frame-seconds high and low
thresholds for triggering an error-frame-seconds link event.
• Enter the threshold high high-seconds command to
set a high threshold in number of seconds. The range is
1 to 900. You must enter a high threshold.
• Enter the threshold high none command to disable the
high threshold.
• Enter the threshold low low-frames command to set a
low threshold in number of frames. The range is 1 to
900. The default is 1.
• Enter the window frames command to set the a polling
window size in number of frames. The range is 100 to
9000; each value is a multiple of 100 milliseconds. The
default is 1000.
Step 8
ethernet oam link-monitor high threshold action
error-disable-interface
(Optional) Configure the router to move an interface to the
error disabled state when a high threshold for an error is
exceeded.
Step 9
exit Return to global configuration mode.
Step 10
interface interface-id Define an Ethernet OAM interface, and enter interface
configuration mode.
Step 11
source-template template-name Associate the template to apply the configured options to
the interface.
Step 12
end Return to privileged EXEC mode.
Step 13
show ethernet oam status [interface interface-id] Verify the configuration.
Step 14
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose