36-17
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 36 Configuring Inverse Muliplexing over ATM
Configuring Marking MPLS Experimental Bits
Example: Configuring UBR Plus
!
interface atm0/ima0
1/200 l2transport
ubr+ 16000 2000
!
Example: Configuring VBR for Real Time Traffic
!
interface atm0/ima0
1/200 l2transport
vbr-rt 10000 5000 37
!
Example: Configuring VBR for Non-Real Time Traffic
!
interface atm0/ima0
1/200 l2transport
vbr-nrt 10000 5000 50
!
Configuring Marking MPLS Experimental Bits
You can configure MPLS through the following procedures:
• Creating a Policy-map for PVP/PVC/ATM IMA Interface, page 36-17
• Applying the Policy-map, page 36-18
• Creating a Table-map, page 36-21
• Creating a Policy-map for SVI Interface, page 36-22
• Applying a Service Policy on SVI Interface, page 36-23
Creating a Policy-map for PVP/PVC/ATM IMA Interface
To configure a policy map, complete the following steps:
SUMMARY STEPS
1. enable
2. configure terminal
3. policy-map map-name
4. class class-name
5. set qos-group-name