10-19
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 10 Configuring Ethernet OAM
To remove an IP SLA operation, enter the no ip sla operation-number global configuration command.
Configuring CFM over EFP with Cross Connect
The CFM over EFP Interface with cross connect feature allows you to:
• Forward continuity check messages (CCM) towards the core over cross connect pseudowires.
To know more about pseudowires, see
Step 8
threshold milliseconds (Optional) Specify the upper threshold value in
milliseconds for calculating network monitoring statistics.
The range is 0 to 2147483647; the default is 5000.
Step 9
timeout milliseconds (Optional) Specify the amount of time in milliseconds that
the IP SLA operation waits for a response from its request
packet. The range is 0 to 604800000; the default value is
5000.
Step 10
exit Return to global configuration mode.
Step 11
ip sla schedule operation-number [ageout seconds]
[life {forever | seconds}] [recurring] [start-time
{hh:mm {:ss} [month day | day month] | pending |
now | after hh:mm:ss}]
Schedule the time parameters for the IP SLA operation.
• operation-number—Enter the IP SLA operation
number.
• (Optional) ageout seconds—Enter the number of
seconds to keep the operation in memory when it is not
actively collecting information. The range is 0 to
2073600 seconds. The default is 0 seconds.
• (Optional) life—Set the operation to run indefinitely
(forever) or for a specific number of seconds. The
range is from 0 to 2147483647. The default is 3600
seconds (1 hour)
• (Optional) recurring—Set the probe to be
automatically scheduled every day.
• (Optional) start-time—Enter the time for the
operation to begin collecting information:
–
To start at a specific time, enter the hour, minute,
second (in 24-hour notation), and day of the
month.
–
Enter pending to select no information collection
until a start time is selected.
–
Enter now to start the operation immediately.
–
Enter after hh:mm:ss to show that the operation
should start after the entered time has elapsed.
Step 12
end Return to privileged EXEC mode.
Step 13
show ip sla configuration [operation-number] Show the configured IP SLA operation.
Step 14
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose