Filter
Top Products
32-34
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter32 IPv6 Support on the Cisco ASR 901 Router
How to Configure IPv6 Support on the Cisco ASR 901 Router
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
GigabitEthernet0/2 is up, line protocol is up
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
GigabitEthernet0/3 is up, line protocol is up
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
GigabitEthernet0/4 is down, line protocol is down
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
GigabitEthernet0/5 is down, line protocol is down
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
GigabitEthernet0/6 is down, line protocol is down
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
GigabitEthernet0/7 is down, line protocol is down
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
GigabitEthernet0/8 is down, line protocol is down
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
GigabitEthernet0/9 is down, line protocol is down
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
GigabitEthernet0/10 is down, line protocol is down
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
GigabitEthernet0/11 is down, line protocol is down
Inbound access list is not set
Outgoing access list is not set
Internet protocol processing disabled
FastEthernet0/0 is administratively down, line protocol is down
Internet protocol processing disabled
Vlan1 is down, line protocol is down
Internet protocol processing disabled
Vlan40 is up, line protocol is up
Internet protocol processing disabled
Loopback0 is up, line protocol is up
Internet protocol processing disabled
Verifying OSPFv3 for IPv6 Configuration
To verify the OSPF for IPv6 configuration, use the show ipv6 ospf command in privileged EXEC mode,
as shown in the example.
Router# show ipv6 ospf
Routing Process "ospfv3 10" with ID 4.4.4.4
Event-log enabled, Maximum number of events: 1000, Mode: cyclic