24-36
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 24 Configuring QoS
Configuring Quality of Service (QoS)
Note You can use the show policy-map command to verify your configuration.
Attaching the Policy Map to an Interface
After you create the policy map, you must attach it to an interface. Policy maps can be attached to either
the input or output direction of the interface.
Complete these steps to attach the policy map to an interface:
Step 1 Enter enable mode.
Router> enable
Step 2 Enter the password.
Password:
password
When the prompt changes to Router, you have entered enable mode.
Step 3 Enter global configuration mode.
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Step 4 Specify the interface to which you want to apply the policy map.
Router(config)# interface gigabitEthernet0/1
Step 5 Use the service-policy command to attach the policy map to an interface. The input and output
parameters specify the direction in which router applies the policy map.
Router(config-if)# service-policy output policy1
Step 6 Exit configuration mode.
Router(config-cmap)# end
Router#
Note You can use the show policy map interface command to verify your configuration.
For more information about configuring classification, see the Cisco IOS Quality of Service Solutions
Configuration Guide, Release 12.2SR.