Filter
Top Products
/-
Pages 8
-
117 through 8-127/8-128: THIRD
CONVERIEB
ASSEUBLY
A10
Table
8-7.
Third Converter Assembly A10, Replaceable Parts
2218A
&
Below Delete the following:
Aioc57, A10C58, A10C59, A10R52, A10R53, and A10U2.
Chacge A10R6 to HP Part Number 0757-0280, Check Digit 3,
RESISTOR
1K 1% .125W F TC=O+-100.
Change A10R8 to HP Part Number 0757
-
0420, Check Digit 3,
RESISTOR 750 1%
.125W F TC=O+-100.
Change AIOR11 to HP Part Number 0757-0405, Check Digit 4,
RESISTOR 162 1% .125W F TC=O+-100.
201 9A00721
Change A1OMP5
to HP Part Number 0363
-
0040, Check Digit
8,
&
Below CONTACT
-
FINGER .58-WD .219-FREE-HGT.
Add AlOMP6 and A1OMP7, HP Part Number 0363-0040, Check Digit 8,
CONTACT
-
FINGER .58-WD .219-FREE-HGT.
1945A00261,263, Delete AlOMP5,AlOMP6, and A1OMP7.
269,271 ,280
&
Below
1942A
&
Below
tlME
The following components have preferred replacements: A10C22,
A10C50, A10C54, A10C55, A1OCR1, A1OCR4, and A10L15. If the
instrument does not contain the preferred replacement values, as
shown
in
the Replaceable Parts
list
and Schematic in the Manual,
then these components should all be replaced at the same
time.
Figure 8
-
13. Third Converter Assembly A10, Component Locations
221
8A
&
Below
Replace Figure 8
-
43 with new Figure 8
-
43 (SERIAL PREFIX 2218A)
included in this Manual Backdating supplement.
Figure 8
-
44. Third Converter Assembly A10, Schematic Diagram
2218A
&
Below Replace funcbion block
(J)
of Figure 8
-
44 with new P/O Figure
8
-
44 (SERIAL PREFIX 2218A) included in this Manual Backdating
supplement
.
Make the following changes in function block (Dl.
Change R6 to 1000.
Cliange R8 to 750.
Change
R11 to 162.
Change
-
10.6 VF to
-
12.6 VF in two places.