Filter
Top Products
tunnel-profile
Deletes a tunnel from the tunnel profile database.
user
user_name
Removes user access to the router for the specified user.
v25-bis-address
address-name
Removes a previously added V25bis address.
Note: If the
address-name
contains spaces (for example, remote site
Baltimore), you cannot enter the command on one line. Type delete
v25-bis-address and press Return. Then enter the name when
prompted.
v34-address
address-name
Removes a previously added V34 address.
Note: If the
address-name
contains spaces (for example, remote site New
York), you cannot enter the command on one line. Type delete
v34-address and press Return. Then enter the name when
prompted.
Disable
Use the disable command to prevent being prompted for a login from a remote
console and to disable modem control . The disable command also disables a
specified interface. If the router has two service ports and you use the disable
modem-control command, specify either service1 or service2.
You can also use the disable command to disable an interface.
Syntax:
disable
console-login
interface...
modem-control
console-login
Disables the user from being prompted for a user ID and password on the
physical console. The default is disabled.
interface
interface#
Causes the specified interface to be disabled after issuing the restart
command. The default is enabled.
modem-control [service1 or service2]
Disables monitoring of modem control lines on the console port. The default
is disable. If the router has two service ports, specify to which service port
you connected the modem, either service1 or service2. To disable
both
service ports, disable them separately.
Enable
Use the enable command to allow login from a remote console, enable modem
control, and enable a specified interface.
Specify enable modem-control carrier-wait or enable modem-control ring-wait.
For routers with two service ports, also specify service1 or service2.
CONFIG Commands
64
MRS V3.2 Software User’s Guide