Filter
Top Products
Bytes Trans
Number of bytes transmitted at the MAC layer.
Test
Use the test command to verify the state of an interface or to enable an interface
that was previously disabled with the disable command. If the interface is enabled
and passing traffic, the test command will remove the interface from the network
and run self-diagnostic tests on the interface.
Syntax:
test
interface#
Note: For this command to work, you must enter the
complete
name of the
command followed by the interface number.
Enter the interface or network number as part of the command. To obtain the
interface number, use the GWCON configuration command. For example, when
testing starts, the console displays the following message:
Testing net 0 TKR/0...
When testing completes or fails, or when GWCON times out (after 30 seconds), the
following possible messages are displayed:
Testing net 0 Eth/0 ...successful
Testing net 0 Eth/0 ...failed
Testing net 0 Eth/0 ...still testing
Some interfaces may take more than 30 seconds before testing is done.
Note: If the interface you are testing is configured as an alternate WAN Reroute
interface, you are prompted:
v If you want to enable the interface’s primary-alternate pairings if WAN
Reroute is currently disabled for the alternate interface.
If you answer
yes
, the same action occurs as when you enter the t5
enable alternate-circuit WAN reroute command described in Configuring
and Monitoring WAN Restoral in
Using and Configuring Features
.
v If you want to test the interface.
Normally an alternate WAN Reroute interface is disabled until it is needed
to back up its corresponding primary interface. If you answer
yes
,a
self-test is started for the interface. If you answer
no
, a self-test does not
occur.
See The WAN Reroute Feature, Using WAN Restoral, and Configuring and
Monitoring WAN Restoral in the
Using and Configuring Features
for
additional information.
Uptime
Use the uptime command to display time statistics about the router, including the
following:
v Number of restarts.
v Number of known crashes.
GWCON Process
142
MRS V3.2 Software User’s Guide