Filter
Top Products
Default Value:
If the ELAN type is token ring, the default is 4544. If the ELAN type
is Ethernet, the default is 1516.
Example:
LEC Config> set frame-size 4544
initial-control-timeout
This parameter sets the value of the initial control timeout used in the
control timeout algorithm described in 302.
Valid Values:
1-10
Default Value:
5
Example:
LEC Config> set initial-control-timeout 10
lecs-atm-address
Specifies the ATM address of the LECS.
If the client is set to auto configure, it attempts to connect to a LECS. If it is
unable to connect to a LECS, then it may try another LECS ATM address.
The LECS ATM addresses that are tried, in order, are:
1. This configured LECS address
2. Any LECS address obtained through ILMI
3. The well-known LECS address defined by the ATM Forum.
No default is provided.
Note: This command should be entered on one command line. It is shown
here on two lines because of spacing.
Example:
LEC Config> set lecs-atm-address
39.84.0F.00.00.00.00.00.00.00.00.00.01.10.00.5A.00.DE.AD.01
les-atm-address
Sets the LES ATM address. This command may be optional or required
depending upon the setting of lecs-auto-config as described in the set
auto-config command on page 300.
v If auto-config is YES, the les-atm-address is not configurable.
v If auto-config is NO, then the les-atm-address is required.
Specify the ATM address of the LES. No default is provided.
Note: This command should be entered on one command line. It is shown
here on two lines because of spacing.
Example:
LEC Config> set les-atm-address
39.84.0F.00.00.00.00.00.00.00.00.00.01.10.00.5A.00.DE.AD.02
mac-address
Sets the MAC address for this LE client. You
may
specify that the client use
the burned-in MAC address of the ATM interface, or you may specify a
Configuring Forum LE Clients
304
MRS V3.2 Software User’s Guide