Filter
Top Products
Specifying a bank number may result in a partial erase of the load image
file if it is large enough to traverse more than one bank.
Example 1:
erase test
Erasing bank 5 ...
Banks 1-4 contain ...
Banks 5-7 have been erased
Example 2:
erase 2
Are you sure you want to erase bank 2? (Yes or [No]): yes
Erasing bank 2 ...
Banks 5-7 has been erased
Example 3:
erase
Loadname or Bank Number: 4
Are you sure you want to erase bank 4? (Yes or [No]): yes
Erasing bank 4...
Bank 1 contains load "vl-29.cfg" which use 131094 bytes
Loaded using TFTP over IP
Filename config
Host 0.0.0.0
Banks 2-3 contain load "vl-22.cfg" which uses 1832848 bytes
Manual Booted using TKR-4/16 at (80001000, 72) as 10.1.155.29
Filename loads/latest-gen.c5-multisna.ldc
Host 128.185.210.125, Gateway 10.1.155.43
Bank 4 has been erased
If the erase fails, a message indicating the failure appears on the console
along with the banks that failed. Failure information will appear in the list
command until the router has been restarted. The router will
not
automatically delete any boot records referencing the image in the failed
banks.
At boot time, if the boot PROM cannot find an image, it will display a
message and try the next boot record.
List
Use the list command to display the current boot and dump configuration database,
the contents of the IBD, and scheduled image load information.
Syntax:
list
addresses
all
boot-entries
bp-device
dump-entries
ibd
view
addresses
Displays the IP addresses and their subnet masks of all the network boot
interfaces entered using the add address command.
Example:
102 MRS V3.2 Software User’s Guide