Filter
Top Products
The Standalone Configuration Process. You are here because
the watchdog timer timed out and/or Autoboot not selected.
Config (only)>
If there is no Token-Ring link active, you receive the following message:
lobe media test failed: function failure
v If you enter Ethernet, you see the following:
Connector Type (AUI/RJ45)[AUTO_CONFIG]:
Interface IP Address: 123.175.56.119
IP Mask (FFFFFF00):
Boot from host: 123.175.68.213
Via Gateway: 123.175.56.190
Boot File Name: ibmMRNS.ldc
Using Ethernet at (6000000, 0)
Trying host 123.175.68.213 via 123.175.56.190
file ibmMRNS.ldc
.loading
..................................
Starting at 1040010
The Standalone Configuration Process. You are here because
the watchdog timer timed out and/or Autoboot not selected.
Config (only)>
v Booting over a WAN
If there is no CTS signal active on the WAN port that you specify, you will receive
the following message: CTS not active on WAN port #
Note: The PPP protocol is currently the only data link layer protocol that can be
used when booting over a WAN interface.
BM (Boot using console queries)
Boots using console queries. The following examples show how to boot the 2210
over the IBD and over the Token Ring, Ethernet, and WAN interfaces. User entries
are shown in bold. To accept the defaults shown in brackets, press Enter.
You can also use this option to boot from a load image file on a TFTP host server.
Note: In the sample interface dialog that follows, the interface type specific to the
2210 appears as either Token Ring or Ethernet in the Devices Types listing
and at the Device Type prompt.
Enter bm at the boot prompt (>). The software prompts you for the following router
information:
Device Types available:
IBD
Token Ring/Ethernet
WAN
Device Type [Token Ring/Ethernet]: IBD
v If you enter IBD, you see the following:
IBD has load(s) load image name
IBD Load Name: load image name
Chapter 9. Boot Options 117