Filter
Top Products
When the first user is added, console login is automatically enabled. Each
user added must be assigned one of the permission levels defined in
Table 5.
When users are added, set login authentication to local. Otherwise a
remote server must be used.
Table 5. Access Permission
Permission Level Description
Administrator (A) Displays configuration and user information,
adds/modifies/deletes configuration and user information.
The Administrator can access any router function.
Operator (O) Views router configuration, views statistics, runs potentially
disruptive tests, dynamically changes router operation, and
restarts the router. Operators cannot modify the permanent
router configuration. All actions can be undone with a
system restart.
Monitor (M) Views router configuration and statistics but cannot modify
or disrupt the operation of the router.
Tech Support Allows your service representative to gain access to the
router if a password is forgotten. Cannot be assigned to
users.
Note: To add a user, you must have administrative permission. You do not
have to reinitialize the router after adding a user.
Example:
add user John
Enter password:
Enter password again:
Enter permission (A)dmin, (O)perations, (M)onitor [A]?
Do you want to add Technical Support access? (Yes or [No]):
Enter password
Specifies the access password for the user. Limited to 80
alphanumeric characters and is case-sensitive.
Enter password again
Confirms the access password for the user.
Enter permission
Specifies the permission level for the user: A, O, or M (see Table 5).
Do you want to add Technical Support access?
This is only an option if the user has a Dial In Access load. See
Table 5.
v25-bis-address
Adds the local and remote numbers of the V.25bis end-points that
communicate with the router. The network
address-name
can be anything,
such as a description of the port. You can use any string of up to 23
printable ASCII characters. The
network-dial-address
is the telephone
number of the local or destination port. For more information, see
“Chapter 41. Using the V.25bis Network Interface” on page 579.
Note: You can use punctuation, such as parentheses and dashes, but the
punctuation is not significant (the router uses only the numbers).
Example: add v25-bis-address
remote-site baltimore 1-909-555-0983
v34-address
Adds the local and remote numbers of the V34 end-points that will be
CONFIG Commands
58
MRS V3.2 Software User’s Guide