Filter
Top Products
Refer to “Chapter 1. Getting Started” on page 3 for information related to the
configuration environment.
SDLC Configuration Commands
The SDLC configuration commands allow you to create or modify the SDLC
interface configuration. This section summarizes and describes the commands you
can issue from the SDLC Config> prompt within the network configuration console.
Defaults for any command and its parameters are displayed on the console, they
are enclosed in brackets immediately following the prompt.
Note: In addition to configuring SDLC using the commands described in this
chapter, you also need to configure SDLC in the DLSw or APPN protocol.
2210 supports SDLC connections over RS-232, X.21, and V.35 serial interfaces.
Table 69 lists SDLC configuration commands and their function.
Table 69. SDLC Configuration Commands Summary
Command Function
? (Help) Displays all the commands available for this command level or lists
the options for specific commands (if available). See “Getting Help”
on page 10.
Add Adds an SDLC end station.
Delete Removes an SDLC end station.
Disable Prevents connections to one of the SDLC link stations.
Enable Allows connections to one of the SDLC link stations.
List Displays configured information for one of the SDLC link stations.
Set Configures specific interface and link-station information.
Exit Returns you to the previous command level. See “Exiting a Lower
Level Environment” on page 11.
Add
Use the add command to add an end station. The router is, by default the primary
end station. If you do not use this command and if you configured an SDLC station
in DLSw or in APPN, the end station is added for you. The software assigns the
following defaults to the station:
v Maximum BTU is maximum allowable by the interface
v Tx and Rx Windows are 7 for MOD 8, 127 for MOD 128
If the defaults are satisfactory, you do not need to add SDLC station.
Syntax:
add
station
Example:
add station
Enter station address (in hex) [C3]?
Enter station name [SDLC_C3]?
Include station in group poll list ([Yes] or No):
Enter max packet size [2009]?
Enter receive window [7]?
Enter transmit window [7]?
Enter station address
The station’s SDLC address in the range 01 - FE.
Configuring SDLC Interfaces
540
MRS V3.2 Software User’s Guide