Filter
Top Products
Table 75. V.25bis Configuration Commands Summary
Command Function
? (Help) Displays all the commands available for this command level or lists
the options for specific commands (if available). See “Getting Help”
on page 10.
List Displays the V.25bis configuration.
Set Sets the local address, connect, disconnect, and no answer
timeouts, number of retries after no answer, the duplexing mode,
command delay timeout, and encoding.
Exit Returns you to the previous command level. See “Exiting a Lower
Level Environment” on page 11.
List
Use the list command to display the current V.25bis configuration.
Syntax:
list
Example:
list
V.25bis Configuration
Duplex = Full
Encoding = NRZ
Local Network Address Name = v403
Local Network Address = 15088982403
Non-Responding addresses:
Retries = 1
Timeout = 0 seconds
Call timeouts:
Command Delay = 0 ms
Connect = 60 seconds
Disconnect = 2 seconds
Cable type = V.35 DTE
Speed = 9600
Duplex
Displays the duplex mode for the interface once the dial connection has
been established.
Encoding
Displays the transmission encoding scheme for the interface once the dial
connection has been established. Encoding is either NRZ (non-return to
zero) or NRZI (non-return to zero inverted).
Local Network Address Name:
Displays the network address name of the local port.
Local Network Address:
Displays the network dial address of the local port.
Non-responding addresses:
Retries
Maximum number of calls the router attempts to make to a
non-responding address during the timeout period.
Timeout
If the router reaches the maximum number of retries to a
V.25bis Configuration Commands
584
MRS V3.2 Software User’s Guide