Filter
Top Products
If multicast-send-avg equals multicast-send-peak, then a constant bit rate
(CBR) multicast send is signalled. Otherwise, a variable bit rate (VBR)
multicast send is signalled. Multicast-send-avg must at least equal
multicast-send peak.
A reserved bandwidth multicast send VCC may improve data transfer rates
in congested networks, but reserving bandwidth and not using it wastes
network resources.
When the multicast-send-type is reserved, then multicast-send-no and
multicast-send-peak must be specified.
Valid Values:
Best Effort or Reserved
Default Value:
Best Effort
Example:
LEC Config> set multicast-send-type best-effort
multiplier-control-timeout
This parameter sets the value of the control timeout multiplier used in the
control timeout algorithm described on page 302.
Valid Values:
2-5
Default Value:
2
Example:
LEC Config> set multiplier-control-timeout 5
path-switch-delay
Sets the path switch delay.
The LEC must ensure that all frames sent through the BUS to a destination
have arrived at the destination before it can start using a Data Direct VCC.
This is accomplished using the flush protocol, or by waiting
path-switch-delay seconds after sending the last packet to the BUS. Smaller
values improve performance, but may result in out-of-order packets in a
heavily congested network.
Valid Values:
An integer number of seconds in the range of 1 to 8.
Default Value:
6
Example:
LEC Config> set path-switch-delay 5
reconfig-delay-min
This parameter sets the minimum delay time when LEC returns to the initial
state. This value must be ≤
reconfig-delay-max
.
Valid Values:
1 - the value of
reconfig-delay-max
Default Value:
1
Configuring Forum LE Clients
306
MRS V3.2 Software User’s Guide