Filter
Top Products
Table 43. ATM LAN Emulation Client ARP Configuration Commands Summary (continued)
Command Function
Remove Removes an ARP cache entry.
Exit Returns you to the previous command level. See “Exiting a
Lower Level Environment” on page 11.
Add
Use the add command to add an ARP cache entry using the MAC address or a
route descriptor.
MAC addresses, and route descriptors are entered as strings of hexadecimal
characters with or without optional separator characters between bytes. Valid
separator characters are dashes (–), periods (.), or colons (:).
Syntax:
add
mac
route-descriptor
Example 1:
ARP config for LEC>add mac
MAC address of LE ARP Entry []? 123456789098
ATM address in 00.00.00.00.00.00:... form []? 390f000000000000000000000000123456789098
Destination Type - REMOTE or LOCAL [Remote]?
Example 2:
ARP config for LEC>add route 12.34
ATM address in 00.00.00.00.00.00:... form []? 390f000000000000000000001234567890988888
ARP config for LEC>
Config
Use the Config command to configure the permanent ARP cache entry QoS
parameters for the ATM forum-specific LAN Emulation Client.
Syntax:
config
arp-entry-number
Example:
ARP config for LEC> config
ARP entry number [1]
Configure LEC ARP entry
Table 44. ATM LAN Emulation Client ARP Config Commands Summary
Command Function
? (Help) Displays all the commands available for this command level or
lists the options for specific commands (if available). See
“Getting Help” on page 10.
Set Sets QoS parameter values.
Exit Returns you to the previous command level. See “Exiting a
Lower Level Environment” on page 11.
Set:
Use the Set command to configure the permanent ARP cache entry QoS
parameters for the ATM forum-specific LAN Emulation Client.
Configuring Forum LE Clients
296
MRS V3.2 Software User’s Guide