Filter
Top Products
The ATCP State fields are the same as those described under the list
control lcp command.
Common Network Number
Network number of the two ends of the point-to-point link. (You
must statically configure both ends of the link to have the same
network number.)
Local Node ID
Unique node number of the local end of the link.
Remote Node ID
Unique node number of the remote end of the link.
Example:
list control dncp
DNCP State: Closed
Previous State: Closed
Time Since Change: 2 hours, 2 minutes and 58 seconds
The DNCP state fields are the same as those described under the list
control lcp command.
Example:
list control osicp
OSICP State: Closed
Previous State: Closed
Time Since Change: 6 hours, 28 minutes and 32 seconds
The OSICP State fields are the same as those described under the list
control lcp command.Example of the List Control BVPC Command
Example:
list control bvcp
BVCP State: Open
Previous State: Ack Sent
Time Since Change: 403 hours, 49 minutes and 2 seconds
The BVCP State fields are the same as those described under the list
control lcp command.
Note: The command word bvcp and the acronym BVCP stand for the
Banyan VINES Control Protocol (BVCP).
Example of the List Control ISRCP Command
Example:
list control isrcp
APPN ISRCP State: Open
Previous State: Ack Rcvd
Time Since Change: 1 hour, 48 minutes and 5 seconds
The APPN ISR control protocol (ISRCP) state fields are the same as those
described under the list control lcp command.Example of the List Control
HPRCP Command
Example:
list control hprcp
APPN HPRCP State: Open
Previous State: Ack Rcvd
Time Since Change: 1 hour, 48 minutes and 10 seconds
The APPN HPR control protocol (HPRCP) state fields are the same as
those described under the list control lcp command
Monitoring PPP Interfaces (Talk 5)
Chapter 33. Configuring and Monitoring Point-to-Point Protocol Interfaces 493