Filter
Top Products
Default Value:
UNI 3.0
Note: Must be compatible with the ATM switch.
Example:
ATM INTERFACE> set uni-version 3.0
network-id
Sets the network id of the ATM interface. Multiple ATM interfaces should
have the same network id if there is ATM connectivity between the
interfaces.
Valid Values:
0 - 255
Default Value:
0
Enable
Use the enable command to enable an ESI in the configuration of your ATM device.
The ATM interface attempts to register only enabled ESIs when it activates.
Syntax:
enable
esi
esi-address
esi
esi-address
Address of End System Identifiers.
Valid Values:
Any 12 hexadecimal digits
Default Value:
none
Example: enable esi
ATM INTERFACE> enable esi 00:00:00:00:00:09
Disable
Use the disable command to disable an ESI in the configuration. ATM components
using disabled ESIs will not become active on the next router restart.
Syntax: disable esi
esi-address
esi
esi-address
Address of End System Identifiers.
Valid Values:
Any 12 hexadecimal digits
Default Value:
none
Example: disable esi
ATM INTERFACE> disable esi 00:00:00:00:00:09
ATM Interface Configuration Commands (Talk 6)
284
MRS V3.2 Software User’s Guide