Filter
Top Products
PPP x>list control ecp
ECP State: Open
Previous State: Ack Sent
Time Since Change: 16 minutes and 40 seconds
Local (transmit) encrypter: DES
Remote (receive) encrypter: DES
Definitions of Terms in the List Control ECP Example
ECP State:
The current state of the point-to-point link. If “Open” then encryption
was successfully negotiated on this link. If not “Open”, encryption is
not running on the link.
Previous State:
The state of the point-to-point link before the state displayed in the
current state field.
Time Since Change:
The elapsed time between the above two state changes.
Local (transmit) encrypter:
This encryption algorithm is used for encrypting the data being sent
on this PPP interface.
Remote (receive) encrypter:
The encryption algorithm is used for decrypting the received data
on this interface.
Example of the List Control LCP Command
Example:
list control lcp
Version: 1
Link phase: Establishing connection (LCP)
LCP State: Listen
Previous State: Req Sent
Time Since Change: 1 minute and 57 seconds
Remote Username: - No Authentication -
Last Identification Rx'd
Time Connected: - No Connection -
LCP Option Local Remote
---------- ----- ------
Max Receive Unit: 2048 1500
Async Char Mask: FFFFFFFF FFFFFFFF
Authentication: None None
Magic Number: 7A8CBFD7 None
Protocol Field Comp: No No
Addr/Cntl Field Comp: No No
32-Bit Checksum: No No
Definitions of Terms in the List Control LCP Example
Version
Displays the current version of the Point-to-Point Protocol.
Link phase
Displays the current activity on the link. This can have one of the
following values:
Dead There is no activity on the link; the interface is down.
Monitoring PPP Interfaces (Talk 5)
Chapter 33. Configuring and Monitoring Point-to-Point Protocol Interfaces 487