Filter
Top Products
Use the set name command to configure the name of the 2210 if the peer
router is configured to authenticate the 2210’s local name.
Note: MS-CHAP is not supported on 4M V2L models.
Note that MS-CHAP cannot be enabled if an external authentication server,
as described in the chapter “Using Local or Remote Authentication” in
Using
and Configuring Features
, has been configured. See “Microsoft PPP CHAP
Authentication (MS-CHAP)” on page 457 for more information.
pap Enables the use of the Password Authentication Protocol. Refer to
“Password Authentication Protocol (PAP)” on page 456 for more information.
spap Enables the use of the Shiva Password Authentication Protocol (SPAP).
Refer to “Shiva Password Authentication Protocol (SPAP)” on page 457 for
more information. The enable spap command is available only in software
loads with the DIALs feature.
List
Use the list command to display information related to the PPP interface and its
protocol parameters and options.
Syntax:
list
all
bcp
ccp
ecp
hdlc
ipcp
ipv6cp
lcp
ncp
all Lists all options and parameters related to the PPP interface.
The list all command displays the output of
all
the individual list...
parameters described below.
bcp Lists the Bridging Network control protocol options.
Example:
list bcp
BCP Options
------------
Tinygram Compression:DISABLED
Tinygram Compression:
Displays whether Tinygram Compression is enabled/disabled.
ccp Displays the currently selected data compression options if data
compression has been enabled. For additional information, see “Using the
Data Compression Subsystem” in
Using and Configuring Features
.
If Microsoft Point-to-Point Encryption (MPPE) and data compression are
both enabled, the type of data compression is MPPC.
Configuring PPP Interfaces (Talk 6)
470
MRS V3.2 Software User’s Guide
|
|
||
|
|
|
|
||
|
|