Filter
Top Products
the name server at least responds quickly with “address not found.” To
determine whether this happens, issue the host command on your workstation
as follows:
workstation> host 5.1.1.1
host: address 5.1.1.1 NOT FOUND
workstation>
If the response takes more than 1 second, select an IP address which resolves
more quickly.
2. In talk 6 configure events and subsystems for remote-logging, as shown in
Figure 8 on page 159.
3. Restart the 2210.
ELS config>set remote source-ip-addr 5.1.1.1
Source IP Addr = 5.1.1.1
ELS config>set remote remote-ip-addr 192.9.200.1
Remote Log IP Addr = 192.9.200.1
ELS config>set remote local-id ** IBM/2210 **
Remote Log Local ID = ** IBM/2210 **
ELS config>set remote no-msgs-in-buffer 100
Number of messages in Remote Log Buffer must be 100-512
Number of Messages in Remote Buffer = 100
ELS config><B>set remote facility log_news
Default Syslog Facility = LOG_NEWS
ELS config>set remote level log_info
Default Syslog Level = LOG_INFO
ELS config>set remote on
Remote Logging is ON
ELS config>list remote
------------------ Remote Log Status -----------------
Remote Logging is ON
Source IP Address = 5.1.1.1
Remote Log IP Address = 192.9.200.1
Default Syslog Facility = LOG_NEWS
Default Syslog Priority Level = LOG_INFO
Number of Messages in Remote Log = 100
Remote Logging Local ID = ** IBM / 2210 **
ELS config>
Figure 7. Configuring the 2210 for Remote Logging
Using ELS
158
MRS V3.2 Software User’s Guide