Filter
Top Products
Table 19. ELS Configuration Command Summary (continued)
Command Function
Delete Deletes an event number from an existing group or deletes an entire
group.
Display Enables message display on the console monitor.
Filter Filter ELS messages based upon the net number.
List Lists information on ELS settings and messages.
Nodisplay Disables message display on the console.
Noremote Disables remote logging to a remote workstation.
Notrace Controls disablement of packet trace events.
Notrap Keeps messages from being sent out in SNMP traps.
Remote Allows messages to be logged to a remote workstation.
Set Sets the pin parameter and the timestamp feature options.
Trace Controls enablement of packet trace events.
Trap Allows messages to be sent to a network management workstation in
SNMP traps.
View Allows viewing of traced packets.
Exit Returns you to the previous command level. See “Exiting a Lower Level
Environment” on page 11.
Add
Use the add command to add an individual event to an existing group or to create
a new group. Group names must start with a letter and are case sensitive. You
cannot append an entire subsystem to a group.
Syntax:
add
group_name subsystem.event_number
Note: If the specified group does not exist, the following prompt asks you to
confirm the creation of a new group:
Group not found. Create new group? (yes or no)
Advanced
Use the advanced command to enter the advanced configuration environment. In
this environment you configure message buffering.
Syntax:
advanced
Clear
Use the clear command to clear all of the ELS configuration information.
Syntax:
clear
Example:
clear
You are about to clear all ELS configuration information
Are you sure you want to do this (Yes or No):
ELS Configuration Commands (Talk 6)
168
MRS V3.2 Software User’s Guide
||
|
|
|
|
||