Filter
Top Products
The other WAN ports must be clocked at 64 Kbps or less.
transmit-delay
value
Allows the insertion of a delay between transmitted packets. This command
ensures a minimum delay between frames so that it is compatible with
older, slower serial devices at the other end. This value is specified as the
number of flag bytes that should be sent between consecutive frames. The
range is 0 - 15. The default is 0.
Accessing the SDLC Relay Monitoring Environment
To monitor information related to the SDLC Relay interface, access the interface
monitoring process by doing the following:
1. Enter the status command to find the PID for GWCON. (See page 9 for sample
output of the status command.)
2. At the OPCON prompt, enter the talk command and the PID for GWCON. For
example:
* talk 5
+
The GWCON prompt (+) is displayed on the console. If the prompt does not
appear when you first enter GWCON, press Return again.
3. At the GWCON prompt, enter the configuration command to see the protocols
and networks for which the router is configured. For example:
+ configuration
See page 130 for more sample output from the configuration command.
4. Enter the protocol sdlc command. For example:
+ prot sdlc
SDLC Relay>
The SDLC Relay prompt is displayed on the console. You can then view
information about the SDLC Relay ports by entering the SDLC Relay monitoring
commands.
SDLC Relay Monitoring Commands
This section summarizes and then explains the SDLC Relay monitoring commands.
The SDLC Relay monitoring commands allow you to view parameters for interfaces
transmitting SDLC Relay frames. The SDLC Relay> prompt is displayed for all SDLC
Relay monitoring commands. Table 68 shows the commands.
Table 68. SDLC Relay Monitoring Commands Summary
Command Function
? (Help) Displays all the commands available for this command level or lists
the options for specific commands (if available). See “Getting Help”
on page 10.
Clear-Port-Statistics Clears SDLC Relay statistics for the specified port.
Disable Temporarily suppresses groups and ports.
Enable Temporarily turns on groups and ports.
List Displays entire SDLC Relay and group specific configurations.
Exit Returns you to the previous command level. See “Exiting a Lower
Level Environment” on page 11.
Configuring and Monitoring SDLC Relay
532
MRS V3.2 Software User’s Guide
||