Filter
Top Products
Tracing event LEC.12: control frames over ATM Forum LEC: interface 1
Note that if the user DISABLEs and TESTs this LEC interface,
the LEC trace settings from Talk 6 Config will take effect.
Example:
subsystems summary
Subsystems Being Traced
ATM net number = 0, VPI Range: 0 - 0
VCI Range: 16 - 16
LEC net number = 1
Trace-Status
Use the trace-status command to get updated information regarding packet trace.
Syntax:
trace-status
Example:
trace-status
------------------------- Configuration -----------------------------
Trace Status:OFF Wrap Mode:OFF Decode Packets:OFF HD Shadowing:OFF
RAM Trace Buffer Size:0 Maximum Trace Buffer File Size:10000000
Max Packet Bytes Trace:256 Default Packet Bytes Traced:100
Trace File Record Size:2048 Stop Trace Event: None
Maximum Hours to HD Shadow: 24
------------------------ Run-time Status ----------------------------
Packets in RAM Trace Buffer:0 Free Trace Buffer Memory:0
Trace Errors:0 First Packet:0 Last Packet:0
Trace Records Stored on HD:0 Trace Buffer File Size:0
HD-Shadowing Time Exceeded? NO
Has Stop Trace Event Occurred? NO
View
Use the view command to enter the View Captured Packet Trace Buffers
Monitoring.
For an explanation of the view commands, see “View” on page 204.
Syntax:
view current
first
jump
last
next
prev
search
hexstring
exit
ELS Net Filter Monitoring Commands
This section describes explains the commands to manipulate ELS net filters. To
enter the filter environment, enter the filter net command at the ELS> prompt.
Enter the monitoring commands at the ELS Filter net> prompt.
ELS Monitoring Commands (Talk 5)
Chapter 13. Configuring and Monitoring the Event Logging System (ELS) 207