Filter
Top Products
log_kern
log_lpr
log_mail
log_news
log_syslog
log_user
log_uucp
log_local0-7
level Specifies a value that, in conjunction with the
facility
value, is used
by the syslog daemon in the remote workstation to determine where
to log messages. This value is used for all remotely-logged ELS
messages unless you specify a different value for a particular ELS
event, range, group, or subsystem with the remote command.
These are all possible syslog level values:
log_emerg
log_alert
log_crit
log_err
log_warning
log_notice
log_info
log_debug
no-msgs
Specifies the number of messages in the buffer for the remote log
before log wraps.
remote_ip_addr
This is an ip address of the form xxx.xxx.xxx.xxx where xxx can be
any integer 0 to 255. It represents the ip address of the remote host
where the log files reside.
source_ip_addr
This is an ip address of the form xxx.xxx.xxx.xxx where xxx can be
any integer 0 to 255.
You should use an IP address that is configured in the 2210 for
easier identification when the IP address or the hostname is shown
in the remotely-logged ELS message. You should also verify that
this IP address is quickly resolved to a hostname by the name
server, or at least that the name server responds quickly with
“address not found.”
To determine that the IP address resolves properly enter the host
command on your workstation as shown:
workstation>host 5.1.1.1
host: address 5.1.1.1 NOT FOUND
workstation>
If the response takes more than 1 second, select an IP address that
resolves more quickly.
local_id
This is any character string of up to 32 characters, which is
ELS Configuration Commands (Talk 6)
178
MRS V3.2 Software User’s Guide