Filter
Top Products
RS-232: CA CB CC CD CF CE
State: OFF OFF OFF OFF OFF OFF OFF
Line Speed: 14.400 Kbps
Last port reset: 1 hour, 28 minutes, 25 seconds ago
Input frame errors:
CRC error 0 alignment (byte length) 0
missed frame 0 too long (> 2182 bytes) 0
aborted frame 0 DMA/FIFO overrun 0
Output frame counters: DMA/FIFO underrun errors 0 Output aborts sent 0
To display the following statistics for a dial circuit, use the interface command
followed by the
interface number
of the dial circuit.
Example:
interface 3
Self-Test Self-Test Maintenance
Nt Nt' Interface CSR Vec Passed Failed Failed
3 2 PPP/1 81640 5C 0 5 0
Point to Point MAC/data-link on V.25bis Dial Circuit interface
The following list describes the output for both serial line interfaces and dial circuits.
Nt Serial line interface number or dial circuit interface number.
Nt′ If “Nt” is a dial circuit, this is the interface number of the V.25bis serial line
interface to which the dial circuit is mapped.
Interface
Interface type and its instance number.
CSR Command and status register addresses of base network.
Vec Interrupt vector address.
Self-Test Passed
Number of self-tests that succeeded.
Self-Test Failed
Number of self-tests that failed.
Maintenance: Failed
Number of maintenance failures.
Adapter cable:
Type of adapter cable that is being used.
V.24 circuit:
Circuit numbers as identified by V.24 specifications.
Nicknames
Common names for the circuits.
RS-232
EIA 232 (also known as RS-232) names for the circuits.
State Current state of the circuits (ON or OFF).
Line speed
The transmit clock speed (approximate).
Last port reset
Length of time since the port was reset.
Input frame errors:
V.25bis Operating Commands
Chapter 42. Configuring and Monitoring the V.25bis Network Interface 593