Filter
Top Products
Table 16. GWCON Command Summary
Command Function
? (Help) Displays all the commands available for this command level or lists the
options for specific commands (if available). See “Getting Help” on page
10.
Activate Enables a newly configured spare interface.
Boot Displays information about how the device was booted last.
Buffer Displays information about packet buffers assigned to each interface.
Clear Clears network statistics.
Configuration Lists status of the current protocols and interfaces.
Disable Takes the specified interface off line.
Environment Enters the Environment system console. Displays the current
temperature and issues an alert when the temperature threshold, high
or low, is passed.
Error Displays error counts.
Event Enters the Event Logging System environment.
Fault Displays information about the last system fault.
Feature Provides access to console commands for independent router features
outside the usual protocol and network interface console processes.
Interface Displays network hardware statistics or statistics for the specified
interface.
Log Sets or views the logging level for events not included in the Event
Logging System.
Memory Displays memory, buffer, and packet data.
Network Enters the console environment of the specified network.
Performance Provides a snapshot of the main processor utilization statistics.
Protocol Enters the command environment of the specified protocol.
Queue Displays buffer statistics for a specified interface.
Reset Disables the specified interface and then re-enables it using new
interface, protocol and feature configuration parameters.
Statistics Displays statistics for a specified interface.
Test Enables a disabled interface or tests the specified interface.
Uptime Displays time statistics for the router.
Activate
Use the activate command to enable a spare interface on this device. See
“Configuring Spare Interfaces” on page 44 for more information.
Syntax:
activate
interface#
Boot
Use the boot command to display boot information for this device.
Syntax:
boot
Example 1:
boot
Booted using Ethernet, line 0 at (80740000, 4) as 128.185.227.220
Filename vl.ldc
Host 128.185.122.17, Gateway 128.185.227.15
GWCON Process
128
MRS V3.2 Software User’s Guide