Filter
Top Products
ipcp Lists the Internet Protocol control protocol options.
Example:
list ipcp
IPCP Options
------------
IPCP Compression: None
Send Our IP Address: Yes
Remote IP Address to Offer if Requested: 10.0.0.3
IPCP compression
Indicates whether the PPP handler accepts compressed IP
headers. PPP supports Van Jacobson TCP/IP header compression
(RFC 1144). Enable this option when the point-to-point link is
running at a low baud rate.
A value of “Van Jacobson” indicates that header compression is
supported. A value of “NONE” indicates that compressed headers
are not being accepted.
Send Our IP Address
Indicates whether IPCP is configured to send the local IP address
for this PPP interface to the remote end of the link in our initial
“Configure Request”. Some PPP implementations require this
information.
ipv6cp
Lists the Internet Protocol version 6 control protocol options.
Example:
list ipv6cp
IPv6CP Options
------------
Send Our IP Address: Yes
Send Our IP Address
Indicates whether IPv6CP is configured to send the local IP address
for this PPP interface to the remote end of the link in our initial
“Configure Request”. Some PPP implementations require this
information.
lcp Lists the parameters and options for the Link Control Protocol.
Example:
PPP 7 Config>list lcp
LCP Parameters
--------------
Config Request Tries: 20 Config Nak Tries: 10
Terminate Tries: 10 Retry Timer: 3000
LCP Options
-----------
Max Receive Unit: 1522 Magic Number: Yes
Peer to Local (RX) ACCM: A0000
Protocol Field Comp(PFC): No Addr/Cntl Field Comp(ACFC): No
Authentication Options
----------------------
Authenticate remote using: none
Identify self as: ibm
Link Control Protocol includes the authentication protocols used to
authenticate the remote peer. If the authentication protocol is either CHAP
or Microsoft PPP CHAP (MS-CHAP), the rechallenge interval is displayed.
Configuring PPP Interfaces (Talk 6)
472
MRS V3.2 Software User’s Guide
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|