Filter
Top Products
Default Value: None
Syntax: cause code remove
value
Example: remove FF
Accessing the Interface Monitoring Process
To access the interface monitoring process for ISDN, enter the following command
at the GWCON (+) prompt:
+ network #
Where
#
is the number of the ISDN interface. You cannot directly access the
monitoring process for dial circuits, but you can monitor the dial circuits that are
mapped to the ISDN interface.
ISDN Monitoring Commands
The following sections explain the ISDN operating commands which allow you to
view the accounting entries, calls, circuits, parameters, and statistics of the ISDN
interfaces. Enter these commands at the ISDN> prompt.
Table 82. ISDN Monitoring Command Summary
Monitoring Command Function
? (Help) Displays all the commands available for this command level or
lists the options for specific commands (if available). See
“Getting Help” on page 10.
Block-calls Blocks incoming calls from a specific caller.
Calls Displays the number of completed and attempted connections
made for each dial circuit mapped to this interface since the
last time statistics were reset on the router.
Channels Displays the statistics for the channels on the ISDN Primary
Rate Interface.
Circuits Displays the status of all data circuits configured on the ISDN
interface.
Dial-dump Displays the operation characteristics of the specified dial
circuit.
L2_counters Lists the L2/L1 states along with some L2 counters.
L3_counters Lists counters of set ups sent/received/accepted.
TEI Lists status of TEI’s (BRI only)
Parameters Displays the current parameters for the ISDN interface.
Signaling-L3 This command is to be used only by product support personell.
Statistics Displays the current statistics for the ISDN interface.
Exit Returns you to the previous command level. See “Exiting a
Lower Level Environment” on page 11.
Block-Calls
Use the block-calls commands to block incoming calls. Caller numbers to be
blocked must be added to the authentication list. The maximum number of caller
blocked calls is 16 per interface.
Syntax:
block-calls
add
list
ISDN Configuration Commands
Chapter 46. Configuring and Monitoring the ISDN Interface 635
|
||
||
||
||
||
||
|
|
|
|
|
||
||