Filter
Top Products
Implement the following steps to configure XTP for the router:
1. To access the XTP config> prompt, enter protocol xtp at the Config> prompt.
2. Add interface 1 to the XTP configuration. Enter add local-dte at the XTP
Config> prompt.
XTP config>add local-dte
Interface number [0]?1
Allow inbound calls without calling DTE address? (Y or N) [N]? n
DTE address [ ]?101
Pref CUG []? 18
CUG (2) []? 2
CUG (3) []?
Pref BI-CUG [0]?
DTE address [ ]?
Entering a null DTE address ends the command input.
3. Add interface 2 to the XTP configuration. Enter add local-dte at the XTP
Config> prompt.
XTP config>add local-dte
Interface number [0]?2
Allow inbound calls without calling DTE address? (Y or N) [N]? n
DTE address [ ]?201
DTE address [ ]?
Entering a null DTE address ends the command input.
4. (Optional) Add XTP protocol-specific CUGs.
add cug
Pref CUG []? 11
CUG (2) []? 12
CUG (3) []? 13
CUG (4) []? 14
CUG (5) []? 15
add bi-cug
Pref BI-CUG []? 21
BI-CUG (2) []? 22
BI-CUG (3) []?
5. Add Remote 1 router as the peer router. Enter add peer-router and enter the
IP address of this router.
XTP config>add peer-router
Router's internal IP Address [0.0.0.0]?128.185.100.2
Connection setup timeout [230]?
6. Add the remote DTE for Remote 1 router. Enter add remote-dte and enter the
IP and DTE address of this DTE.
XTP config>add remote-dte
DTE address [ ]?301
Peer router's internal IP Address [0.0.0.0]?128.185.100.2
Peer router's internal IP Address [0.0.0.0]?
Note: A remote DTE is
required
only if one of the following applies:
v The Concentrator Router will be initiating XTP connections to the
remote DTE due to incoming calls from its local DTEs.
v The DTE is part of an XTP PVC definition.
7. Add Remote 2 router (as the peer router). Enter add peer-router and enter the
IP address of this router.
XTP config>add peer-router
Router's internal IP Address [0.0.0.0]?128.185.100.3
Connection setup timeout [230]?
8. Add the remote DTEs for Remote 2 router. Enter add remote-dte and enter the
IP and DTE addresses of this DTE.
XTP config>add remote-dte
DTE address [ ]?401
Peer router's internal IP Address [0.0.0.0]?128.185.100.3
Peer router's internal IP Address [0.0.0.0]?
Using XTP
370
MRS V3.2 Software User’s Guide