Filter
Top Products
Remove
Use the remove command to delete an ATM virtual interface. The virtual ATM
interface on the real ATM interface with the specified interface number will be
removed from the SRAM configuration records. If you do not specify an interface
number, the last ATM virtual interface on this real ATM interface will be deleted. If
you enter a question mark (?), all ATM virtual interfaces on the current real ATM
interface will be listed and you can select from that list the interface you want to
remove.
Syntax:
remove
n
Example: remove 5
Virtual ATM 5 deleted successfully.
ATM Virtual Interface config>
Accessing the ATM Monitoring Process
Use the following procedure to access the ATM monitoring commands. This process
gives you access to an ATM’s
monitoring
process.
1. At the OPCON prompt, enter talk 5. (For more detail on this command, refer to
“Chapter 3. The OPCON Process” on page 25.) For example:
* talk 5
+
The GWCON prompt (+) is displayed on the console. If the prompt does not
appear when you first enter the console, press Return again.
2. Enter interface at the + prompt to display a list of configured interfaces.
3. Record the interface numbers.
4. Enter network followed by the number of the ATM interface.
+ network 5
ATM+
The ATM monitoring prompt (ATM+) is displayed.
ATM Monitoring Commands
This section summarizes the ATM monitoring commands for monitoring ATM
interfaces. Enter the commands at the ATM+ prompt.
Table 38. ATM monitoring command Summary
Command Function
? (Help) Displays all the commands available for this command level or
lists the options for specific commands (if available). See
“Getting Help” on page 10.
Interface Displays the ATM Interface+ prompt from which you can
monitor the ATM Interface, as described in “ATM Interface
Monitoring Commands (ATM INTERFACE+ Prompt)” on
page 287 .
Atm-llc Displays the ATM LLC+ prompt from which you can monitor
endpoints, a set of user clients, and a set of ATM channels.
Exit Returns you to the previous command level. See “Exiting a
Lower Level Environment” on page 11.
ATM Virtual Interface Configuration Commands (Talk 6)
286
MRS V3.2 Software User’s Guide