Filter
Top Products
event
subsystem.event#
Displays the logging level, the message, and the count of the specified
event.
Example:
list event ip.007
Level: p-TRACE
Message: source_ip_address -> destination_ip_address
Active: Count: 84182
If Remote-logging had been activated for this event, and the
syslog_facility
and
syslog_level
values were log_daemon and log_crit, the last lines would
look like:
Active: R count:84182
Syslog Facility: log_daemon Syslog Level: log_crit
filter-status
Lists ELS net number filters.
groups
group.name
Displays the user-defined group names.
pin Lists the current number of ELS event messages sent per second in SNMP
traps. This is a threshold value that can be used to reduce the amount of
SNMP trap traffic.
Example:
list pin
Pin: 100 events/second
remote-log status
Lists the current values of the remote logging options set in the set
remote-logging command.
Example:
list r
Remote Logging is On
Source Ip Address = 192.9.200.8
Remote Log IP Address = 192.9.200.1
Default Syslog Facility = LOG_USER
Default Syslog Priority Level = LOG_INFO
Number of Messages in Remote Log = 256
Remote Logging Local ID = SPHINX
subsystem
subsystem.name
Lists event names, the total number of events that have occurred, and their
descriptions.
Note: Although ELS supports all subsystems on the router, not all devices
support all subsystems. See
ELS Messages
for a list of currently
supported subsystems.
subsystem
subsystem.name
Lists all events, logging levels, and messages for the specified subsystem.
Example:
list subsystem eth
Event Level Message
ETH.001 P-TRACE brd rcv unkwn type packet_type source_Ethernet_address ->
destination_Ethernet_address nt network
ETH.002 UE-ERROR rcv unkwn typ packet_type source_Ethernet_address ->
destination_Ethernet_address nt network
ETH.010 C-INFO LLC unk SAP DSAP source_Ethernet_address ->
destination_Ethernet_address nt network
ELS Monitoring Commands (Talk 5)
Chapter 13. Configuring and Monitoring the Event Logging System (ELS) 191
|
|
|
|